If you are not a member of the Local Administrators or Network Operators group and.If you are a member of the Network Operators group you can run the commands from any command prompt.In order to run the Netsh advfirewall commands you must have the correct permissions. This can happen if the remote computer does not support VDS, or if a connection cannot be established because it was blocked by Windows Firewall. The error reported is: The RPC server is unavailableĭisk Management could not start Virtual Disk Service (DS) on “ComputerName”. When you attempt to connect to a Windows Server 2008 Core installation via Event Viewer you may receive the following message:Įvent Viewer cannot connect to computer “ComputerName”. When you attempt to connect to a Windows Server 2008 Core installation via Device Manager you may receive the following message:ĬomputerName” Make sure that this computer is on the network, has remote administration enabled, and is running the “Plug and Play” and “Remote registry” services.

If you do not configure the firewall to allow remote administration via MMC you will get an error. To administer the Server Core installation from a remote MMC you must configure the Windows Firewall. Here are some netsh commands that will help you administer your Server Core installation remotely through MMC snap-ins.Īdministration of Server Core from a Remote MMC Windows Server 2008 Core introduces some challenges in administering servers without an explorer shell. Hello, this is LaNae Wade from the Directory Services team. First published on TechNet on Jun 05, 2008

Windows firewall remote management